1976 SeaCraft Cuddy

A complete refit was completed in 2018 at a cost of about $110k.  The only thing original is the hull.  Extremely nice all the way around.

Updates include but not limited to:

• 2018 Suzuki 300hp with 70 hours and warranty to 2024
• Dual helm electronic controls with full functionality at both
• 2019 Coastline aluminum trailer
• Garmin GPSMAP 1042 XSV at lower station
• Garmin GPSMAP 942 XS at upper station
• Garmin GT51M Chirp transducer
• Standard Horizon GX2200B Standard Matrix AIS/GPS VHF radio
• Fusion RA70NI Stereo (integrated into Garmin system)
• Wet Sounds Stealth 10 Speaker Bar
• Garmin GXM 53 XM Weather/Radio
• 2x Lumitec SeablazeX underwater lights
• Hermco fiberglass motor bracket
• Awlgrip painted from water line to rub rail
• 90 gallon fuel capacity (single tank replaced with new)
• Bennett Marine trim tabs with electronic indicator
• Seastar hydraulic steering is all new, helms, hoses and cylinder on motor (complete dual station functionality)
• 2 Battery system with Blue Sea Systems Automatic Charging Relay
• 2x Rule 2000 bilge pumps. Each on float switch and also each on independent manual switches
• Under gunnel LED lights, LED spot light and LED spreader lights
• Seadek helm pad at upper station and on motor bracket
• Taco Grand Slam 380 outrigger bases (outriggers not included)
• 4 Gunnel rod holders; 2 transom rod holders; 7 rod holders on hard top
• Custom built seat boxes - tackle station built into one, open storage in the other. Both also have built-in cooler that works great for day trips for drinks, bait, and fish boxes
• Live well approximately 45 gallons built into transom

The hardtop is fiberglass with a light blue gelcoat. You will not find aluminum work that was done any more professionally that this one. It is all polished aluminum and the welds are pristine in quality. The top hinges down into the cockpit which makes the trailer towing height about 11'6".  

In addition to the above list, the seller also replaced all interior upholstery, rub rail, navigation and interior lights, all hardware, bilge pumps, new gelcoat in the cockpit and on the bow, live well and washdown pumps. New teak cabin door and all other teak was redone. The windshield frame was removed and powder coated and new glass was installed. All wires, hoses, clamps were also replaced as part of the restoration.

Must be seen to appreciate